What personal protective equipment should be used when operating a drill press?

In terms of personal protective equipment (PPE), the only piece of equipment that’s absolutely necessary when operating a drill press is a pair of high-grade, shatter-proof goggles with side shields. Eye injuries are known to occur when metal shards or debris are shot from underneath the drill.

What PPE must be worn when using the drill press?

PERSONAL PROTECTIVE EQUIPMENT

Safety glasses must be worn at all times in work areas. Long and loose hair must be contained. Gloves must not be worn. Sturdy footwear must be worn at all times in work areas.

What should you do when operating a drill press?

Drill Press Safety Rules

  1. Run drill at correct RPM for diameter of drill bit and material. …
  2. Always hold work in a vise or clamp to the drill table.
  3. Use a correctly ground drill bit for the material being drilled. …
  4. Use the proper cutting fluid for the material being drilled. …
  5. Remove chips with a brush, never by hand.

Which safety item should be used when handling a drill?

Safety goggles are always a good idea when using a power drill. You may also want to use a breathing mask if the material you’re drilling produces a lot of dust or shavings. Gloves can help protect your hands, but only if they are form-fitting and not baggy. Loose gloves can get caught in the drill.

THIS IS IMPORTANT:  How do companies secure data?

What are 3 examples of PPE and when should they be used?

Personal protective equipment, commonly referred to as “PPE”, is equipment worn to minimize exposure to a variety of hazards. Examples of PPE include such items as gloves, foot and eye protection, protective hearing devices (earplugs, muffs) hard hats, respirators and full body suits.

What will happen if center drill is not used before starting a drill?

Without using a pre-center drill hole, the initial point of engagement is seated on the chisel edge. The cutter may therefore slip on the workpiece and consequently angular drill holes may be generated. In addition, tool break may be observed in the case of using brittle cutters (such as WC).

What should you never leave in the chuck of a drill press?

Never leave chuck key in press. It should only be on the chuck when power is off and you are changing a bit. Always follow 4 inch rule. Never force the bit.

What will happen if you try to grab the chuck to stop the drill press?

Never reach around or under a rotating drill bit or grab the chuck to stop a drill press. This can result in hand puncture or other serious injury. … Never stop the rotation of the drill chuck, spindle, or stock rotating on bit with your hands or fingers.